Magnetization of Permanent Magnets in Wind Turbines: Why Is Magnetization Uniformity More Important for Large Permanent Magnets?
End-to-End Solution for Magnetization Automation
Automated Magnetic Charging Integrated Solution
Permanent magnets in wind turbines are typically very large; the size and weight of a single magnet are significantly greater than those of magnets in ordinary electric motors. When magnetizing such large magnets, the most critical factor is often not whether saturation can be achieved, but rather the uniformity of magnetization—that is, whether the magnetic flux distribution is consistent across all regions of the same magnet.

Poor uniformity can lead to a series of problems. Where the magnetic flux in the magnet is locally weak, the induced electromotive force in the generator in that area decreases, resulting in a reduction in the overall power generation efficiency of the unit. More troubling still, an uneven distribution of magnetic flux density generates periodic unbalanced forces as the rotor rotates; over the long term, this can accelerate bearing wear and amplify noise.

There are two main reasons why large magnets are difficult to magnetize uniformly. First, due to their large size, the magnetic field generated by the magnetizing coils attenuates significantly within the magnet, resulting in a substantial difference in magnetic field strength between the center and the edges. Second, in a multipole structure, the magnetization directions of adjacent poles alternate, resulting in more pronounced inter-pole magnetic leakage and interference compared to smaller magnets, which places higher demands on coil design and positioning accuracy.

The solution involves adopting a holistic multipole magnetization approach, combined with specially designed distributed coils, to ensure the magnetic field is as uniform as possible within the magnet’s effective region. Prior to magnetization, the coil layout and current parameters are determined through simulation, followed by actual measurements of the magnetic flux distribution using prototype samples. The process is then fine-tuned iteratively until the uniformity meets the requirements. Jiuju Automation’s large-scale permanent magnet magnetization equipment has been used in the mass production of various types of large-size permanent magnets, delivering stable control over magnetization uniformity. For applications such as wind power—which demand a high degree of consistency—Jiuju Automation provides a flux distribution inspection solution and parameter tuning recommendations upon delivery to help production lines establish uniformity acceptance criteria.
Magnetization of Magnetic Materials
3C Electronic Magnetization
Motor Rotor Magnetization
Car Speaker Magnetization
New Energy Vehicle Industry
Medical Equipment Industry
Other Industries
Jiu Ju Magnetizer



























